Overview Of Important Parameters; Profienergy - Siemens SINAMICS S120 Function Manual

10.Click "Open object with STARTER" again
Figure 11-51 New project completed in STARTER
11.3.8.3

Overview of important parameters

Overview of important parameters (see SINAMICS S120/S150 List Manual)
• p8929
• p9601
• p9801
11.3.9

PROFIenergy

PROFIenergy is an energy management system for production plants, based on the
PROFINET communication protocol. The functionality is certified in the PROFIenergy profile
of the PNO. Drive units which have PROFIenergy functionality, can be certified in an
approved laboratory. Certified devices support the PROFIenergy commands and respond
accordingly to the requirements and operating states.
SINAMICS supports PROFIenergy profile V1.1. PROFIenergy commands are transferred
from the controller to the drive with PROFINET data sets in acyclic operation. The
PROFIenergy commands are transferred using the PROFINET data set 0x80A0.
Drive functions
Function Manual, (FH1), 04/2014, 6SL3097-4AB00-0BP4
After completing the last save operation, you will see in the STARTER window that the
PROFIsafe telegrams have been assigned to PN-IO-1 and the drive telegrams to PN-IO.
If there is a checkmark after each telegram type in STARTER, then the Shared Device
has been successfully configured.
PN number of remote controllers
SI enable functions integrated in the drive (Control Unit)
SI enable functions integrated in the drive (Motor Module)
11.3 Communication via PROFINET IO
Communication
745