Monitoring Functions - Siemens SINAMICS S120 Function Manual

Overview of important parameters (see SINAMICS S120/S150 List Manual)
• p2533[0...n]
• p2534[0...n]
• p2535[0...n]
• p2536[0...n]
• p2537
• p2538[0...n]
• p2539[0...n]
• p2540
• p2541
8.7.4

Monitoring functions

Figure 8-10
The position controller monitors the standstill, positioning and following error.
Standstill monitoring is activated via binector inputs p2551 (setpoint stationary) and p2542
(standstill window). If the standstill window is not reached once the monitoring time (p2543)
has elapsed, fault F07450 is triggered.
Positioning monitoring is activated via binector inputs p2551 (setpoint stationary), p2554 =
"0" (travel command not active) and p2544 (positioning window). Once the monitoring time
(p2545) has elapsed, the positioning window is checked once. If this is not reached, fault
F07451 is triggered.
Drive functions
Function Manual, (FH1), 04/2014, 6SL3097-4AB00-0BP4
LR position setpoint filter time constants
LR speed feedforward control factor
LR speed feedforward control balancing filter dead time
LR speed feedforward control balancing filter PT1
CI: LR position controller adaptation
LR proportional gain
LR integral time
CO: LR position controller output speed limit
CI: LR position controller output speed limit signal source
Standstill monitoring, positioning window
Function modules
8.7 Closed-loop position control
463