Siemens SINAMICS S120 Function Manual page 752

Communication
11.3 Communication via PROFINET IO
Activating the diagnostic function
The diagnostics function is activated or deactivated via the parameterization of the relevant
configuration tool (HW Config, TIA Portal, etc.).
Figure 11-54 Activation of PROFINET
The following parameter assignments are possible:
Setting
Inactive
PROFIdrive error classes
When establishing the communication between SINAMICS and a master/controller, the
activated diagnostics mode of this controller is first transferred to the drive. With activated
diagnostics, SINAMICS first transfers all pending messages to the controller.
Messages
The message texts are described in detail in the SINAMICS S120/S150 List Manual, Section
3.1.2 "Explanations on the list of faults and alarms". A current list of the message texts can
be found in the "Message classes and coding of different diagnostics interfaces" table.
752
Code for parameter assignment
0
1
Function Manual, (FH1), 04/2014, 6SL3097-4AB00-0BP4
Drive functions