INVT Goodrive3000 GD3000-01-055G-12 Operation Manual page 40

Goodrive3000 series medium voltage inverters
When this function code is set as a value other than zero, if the interval between one communication and
the next communication exceeds the time for communication overtime, the system will report an error of
485 communication fault (CE). Generally this parameter is set as invalid. In a system that communicates
continuously, this parameter can be set to monitor the communication state.
Function
Name
code
Transmission error
P11.05
processing
The function code is used to set the solution mode when transmission fault occurs.
Function
Name
code
Communication
P11.06
processing
The function code is used to select the communication processing.
0: Response to write; PWM rectifier responses to read/write commands from upper PC.
1: No response to write; PWM rectifier responses to read commands from upper PC only. The
communication efficiency can be improved.
Function
Name
code
CANopen
P11.09 communication
address
P11.10 CANopen baud rate
CANopen
P11.11 communication fault
delay
CANopen
P11.12 communication
protocol
Detailed parameter description
0: Report fault and coast to stop
1: Not to report fault and keep
working
2: Not to report fault and stop (only in
the communication control mode)
3: Not to report fault and stop (in all
control modes)
Detailed parameter description
0x00~0x11
LED ones:
0: Response to write
1: No response to write
LED tens:
0: Reserved
1: Reserved
Detailed parameter description
0~127
0: 50K BPS
1: 125K BPS
2: 250K BPS
3: 500K BPS
4: 1M BPS
0.0 (invalid), 0.1~100.0s
0: Common control protocol
1: Internal master-slave
communication protocol
-39-
Goodrive3000 series PWM rectifier
Setting range
0~3
Setting range
0x00~0x11
Setting range
0~127
0~4
0.1~100.0s
0~1
Default
0
Default
0x00
Default
1
3
0.0s
0