List Of Function Parameters - INVT Goodrive3000 GD3000-01-055G-12 Operation Manual

Goodrive3000 series medium voltage inverters Goodrive3000 series converter

6.4 List of function parameters

The function parameters of Goodrive3000 inverters have been divided into 22 groups (P00~P21)
according to the function. Each function group contains certain function codes applying 3-level menus.
For example, "P08.08" means the eighth function code in the P08 group function, P29 group is factory
reserved, and users are forbidden to access these parameters.
For the convenience of function codes setting, the function group number corresponds to the first level
menu, the function code corresponds to the second level menu and the function code corresponds to the
third level menu.
1. Below is the instruction of the function lists:
The first line "Function code": codes of function parameter group and parameters
The second line "Name": full name of function parameters
The third line "Detailed instruction of parameters": Detailed illustration of the function parameters
The forth line "Setting range": valid setting range of the function parameters
The fifth line "Default value": the original factory set value of the function parameters
The sixth line "Modify": the modifying character of function codes (the parameters can be modified or not
and the modifying conditions), below are the instructions:
"○": means the set value of the parameter can be modified on stop and running state;
"◎": means the set value of the parameter cannot be modified on the running state;
"●": means the value of the parameter is the real detection value which cannot be modified.
(The inverter has limited the automatic inspection of the modifying character of the parameters to help
users avoid mismodifying)
The seventh column "Fieldbus ratio": the ratio between the displayed value on the screen and the actual
value;
The eighth column "No.": the serial number of the function code in the whole function parameters, or
register address during communication;
2. "Parameter radix" is decimal (DEC), if the parameter is expressed by hex, then the parameter is
separated from each other when editing. The setting range of certain bits are 0~F (hex).
3. "Default value" means the function parameter will restore to the default value during default
parameters restoring. But the detected parameter or recorded value will not be restored.
4. For a better parameter protection, the inverter provides password protection to the parameters. After
setting the password (set P07.00 to any non-zero number), the system will come into the state of
password verification firstly after the user press PRG/ESC to come into the function code editing state.
And then "0.0.0.0.0." will be displayed. Unless the user input right password, they cannot enter into the
system. For the factory setting parameter zone, it needs correct factory password (remind that the users
can not modify the factory parameters by themselves, otherwise, if the parameter setting is incorrect,
damage to the inverter may occur). If the password protection is unlocked, the user can modify the
password freely and the inverter will work as the last setting one. When P07.00 is set to 0, the password
can be canceled. If P07.00 is not 0 during powering on, then the parameter is protected by the password.
When modify the parameters by serial communication, the function of the password follows the above
rules, too.
5. When using serial communication to modify the function parameters, the functions of the user
password follow the above rules.
-154-