Agilent Technologies N9360A Programming Manual page 97

N9360A Multi UE Tester CDMA2000 Programming Manual
bit 0 (1) :For testing RFCH1
bit 1 (2) : For testing RFCH2
bit 2 (4) :For testing RFCH3
bit 3 (8) :For testing RFCH4
bit 4 (16) :For testing RFCH5
bit 5 (32) :For testing RFCH6
The choices for each bit are 1 for Run and 0 for --- (skip). At
preset, this is set to 63 (all bits are set to 1).
Sensitivity/PER1
CONFigure:SEQuence:SENSitivity:PER1 <int>
This command requires the installation of the Option C02.
This command is valid when CDMA mode is set to EVDO. This
defines whether to include Sensitivity/PER1 test in the test
sequence. <int> is a sum of the values of all the 6 bits as
follows:
bit 0 (1) :For testing RFCH1
bit 1 (2) : For testing RFCH2
bit 2 (4) :For testing RFCH3
bit 3 (8) :For testing RFCH4
bit 4 (16) :For testing RFCH5
bit 5 (32) :For testing RFCH6
The choices for each bit are 1 for Run and 0 for --- (skip). At
preset, this is set to 63 (all bits are set to 1).
Sensitivity/PER2
CONFigure:SEQuence:SENSitivity:PER2 <int>
This command requires the installation of the Option C02.
Programming Command Reference
5
5-47