Agilent Technologies N9360A Programming Manual page 138

5
Programming Command Reference
5-88
• <int 2> contains test contents currently being executed by
sum of the value of 10 bits as follows:
bit 0 (1) :Access Probe Power
bit 1 (2) :ILP (Down)
bit 2 (4) :ILP (Up)
bit 3 (8) :Max TX Power
bit 4 (16) :Min TX Power
bit 5 (32) :Frequency Error
bit 6 (64) :Rho/Multi-code Rho
bit 7 (128) :Time Offset
bit 8 (256) :Sensitivity/FER
bit 9 (512) :Abort
Each bit is set to 0 if the test is passed or skipped, or each bit is
set to 1 if the test is fail. If there are no test results, all bits are
set to 1, and the value 1023 is returned.
When CDMA mode is EVDO:
• <int 1> contains test contents currently being executed by
sum of the value of 8 bits as follows:
bit 0 (1) :UATI Assign
bit 1 (2) :Session Opened
bit 2 (4) :BS Call
bit 3 (8) :RF Test
bit 4 (16) :Softer Handoff
bit 5 (32) :Connection Close
bit 6 (64) :Session Close
bit 7 (128) :Abort
Each bit is set to 0 if the test is passed or skipped, or each bit is
set to 1 if the test is fail. If there are no test results, all bits are
set to 1, and the value 255 is returned.
• <int 2> contains test contents currently being executed by
sum of the value of 11 bits as follows:
bit 0 (1) :Access Probe Power
N9360A Multi UE Tester CDMA2000 Programming Manual