N9360A Multi UE Tester CDMA2000 Programming Manual
Frequency Error
CONFigure:SEQuence:FERRor <int>
This command defines whether to include Frequency Error test
in the test sequence. <int> is a sum of the values of all 6 bits as
follows:
bit 0 (1) :For testing RFCH1
bit 1 (2) : For testing RFCH2
bit 2 (4) :For testing RFCH3
bit 3 (8) :For testing RFCH4
bit 4 (16) :For testing RFCH5
bit 5 (32) :For testing RFCH6
The choices for each bit are 1 for Run and 0 for --- (skip). At
preset, this is set to 63 (all bits are set to 1).
Rho
CONFigure:SEQuence:RHO <int>
This command is valid when CDMA mode is set to MC1X. This
defines whether to include Rho test in the test sequence when
F1R1 or F2R2 is set by the Radio Configuration command. <int> is
a sum of the values of all the 6 bits as follows:
bit 0 (1) :For testing RFCH1
bit 1 (2) : For testing RFCH2
bit 2 (4) :For testing RFCH3
bit 3 (8) :For testing RFCH4
bit 4 (16) :For testing RFCH5
bit 5 (32) :For testing RFCH6
The choices for each bit are 1 for Run and 0 for --- (skip). At
preset, this is set to 63 (all bits are set to 1).
Multi-code Rho
CONFigure:SEQuence:MRHO <int>
This command requires the installation of the Option C02.
This command defines whether to include Multi-code Rho test
in the test sequence in the following case:
Programming Command Reference
5
5-45