Agilent Technologies N9360A Programming Manual page 120

5
Programming Command Reference
5-70
This command is valid when CDMA mode is set to MC1X. This
sets the low and high limits for Rho test in each band set by the
Band command on page
to 1.000 in 0.001 steps. At preset, this is set to 0.944 (for the
low limit) and 1.000 (for the high limit).
This query command returns the set low and high limits of Rho
test with real separated by a comma. The range of the value is
same as that of the command parameter.
Multi-code Rho
CONFigure:CONDition:LIMit:MRHO <real LO>,<<
<real HI>
CONFigure:CONDition:LIMit:MRHO?
This command sets the low and high limits for Multi-code Rho
test in each band set by the
allowable range is from 0.800 to 1.000 in 0.001 steps. At
preset, this is set to 0.944 (for the low limit) and 1.000 (for
the high limit).
This query command returns the set low and high limits of
Multi-code Rho test with real separated by a comma. The range of
the value is same as that of the command parameter.
Origin Offset
CONFigure:CONDition:LIMit:OriginOFFset <<
<real LO>,<real HI>
CONFigure:CONDition:LIMit:OriginOFFset?
This command sets the low and high limits for Origin Offset test
in each band set by the
allowable range is from -99.9 to 0.0 (dBc) in 0.1 steps. At
preset, this is set to -99.9 (dBc) (for the low limit) and 0.0
(dBc) (for the high limit).
This query command returns the set low and high limits of
Origin Offset test with real separated by a comma. The range of
the value is same as that of the command parameter.
N9360A Multi UE Tester CDMA2000 Programming Manual
36. The allowable range is from 0.800
Band command on
Band command on page
page 36. The
36. The