Agilent Technologies N9360A Programming Manual page 116

5
Programming Command Reference
5-66
PER Max Packets
CONFigure:CONDition:PER:MAXPackets <int>
CONFigure:CONDition:PER:MAXPackets?
This command requires the installation of the Option C02.
This command is valid when CDMA mode is set to EVDO. This
sets the PER Max Packets. The allowable range is from 25 to
10000000 in 1 steps. At preset, this is set to 10000.
This query command returns the setting of PER Max Packets with
integer. The range of the value is same as that of the command
parameter.
PER Confidence
CONFigure:CONDition:PER:CONFidence 95%|OFF
CONFigure:CONDition:PER:CONFidence?
This command requires the installation of the Option C02.
This command is valid when CDMA mode is set to EVDO. This
sets the PER Confidence. The parameter is 95% or OFF. At preset,
this is set to 95%.
This query command returns the setting of PER Confidence with
the value of 95% or OFF.
Access Probe Power Measurement
CONFigure:CONDition:APpower:STATe ON|OFF|1|0
CONFigure:CONDition:APpower:STATe?
This command defines whether to include Access Probe Power
Measurement test in the test sequence. <int> is 1 for Run or 0
for --- (skip). At preset, this is set to 1.
This query command returns the setting of the Access Probe
Power Measurement test with integer value of 1 or 0.
N9360A Multi UE Tester CDMA2000 Programming Manual