Agilent Technologies N9360A Programming Manual page 100

5
Programming Command Reference
5-50
CONFigure:SEQuence:LOSS:RFOUT:CHANnel4 <<
<real 1>,<real 2>,<real 3>,<real 4>,<real 5>
CONFigure:SEQuence:LOSS:RFOUT:CHANnel4?
CONFigure:SEQuence:LOSS:RFOUT:CHANnel5 <<
<real 1>,<real 2>,<real 3>,<real 4>,<real 5>
CONFigure:SEQuence:LOSS:RFOUT:CHANnel5?
CONFigure:SEQuence:LOSS:RFOUT:CHANnel6 <<
<real 1>,<real 2>,<real 3>,<real 4>,<real 5>
CONFigure:SEQuence:LOSS:RFOUT:CHANnel6?
This command sets the RF output path loss on each RFCH,
<real 1> BAND0:CELUS, <real 2> BAND3:CELJP,
<real 3> BAND1:PCSUS, <real 4> BAND4:PCSKR and <real
5> BAND6:IMT-2K respectively. The allowable range is from
-9.9 to +9.9 in 0.1 steps. At preset, this is set to 0.0.
This query command returns the setting of the RF output path
loss on each channel with real. The range of the values is same
as that of the command parameter.
Location Update
CONFigure:SEQuence:SIGNaling:LOCUpdate
ON|OFF|1|0
CONFigure:SEQuence:SIGNaling:LOCUpdate?
This command is valid when CDMA mode is set to MC1X. This
sets whether to include the Location Update in a test flow. The
parameter is ON (1) for Run or OFF (0) for --- (skip). At preset,
this is set to 1.
This query command returns the setting of Location Update with
integer value of 1 or 0. The meaning of the return value is same
as that of the command parameter.
MS Call
CONFigure:SEQuence:SIGNaling:MSCAll ON|OFF|1|0
CONFigure:SEQuence:SIGNaling:MSCAll?
N9360A Multi UE Tester CDMA2000 Programming Manual