Agilent Technologies N9360A Programming Manual page 194

5
Programming Command Reference
5-144
Code Domain Power
TXANalyzer:CDPWr:PILot:STATe ON|OFF|1|0
TXANalyzer:CDPWr:PILot:STATe?
This command sets whether to execute the Code Domain
Domain Power test.
The item settings for Code Domain Power: Pilot, Traffic
(Fundamental) test are available when Pilot Only,
Pilot+Sync+Pch+OCNS+Fch, or
Pilot+Sync+Pch+OCNS+Fch+Sch is set by the Modulation
command.
The test items Code Domain Power: Pilot, RRI, DRC, ACK, and
Data can be set when Cont Pilot, Pilot+MAC Cntrl, or
Pilot+MAC+Cntrl+Tch is set by the Modulation command and
1 or 2 (Release 0) is set by the 3GPP2 Configuration command.
While, test items Code Domain Power: Pilot, RRI, DRC, ACK,
DSC, and Data can be set when 3 or 4 (Release A) is set by the
3GPP2 Configuration command.
Change System
TXANalyzer:SYSTem GSM|WCDMA|CDMA2000
TXANalyzer:SYSTem?
This command switches the system (GSM/W-CDMA/cdma2000).
This command is valid in Stand-by status. GSM is valid when
G00 option is installed in the Tester and WCDMA is valid when
W00 option is installed. Each system mode is initialized at
preset (including *RST). Namely, GSM (GSM, GPRS, and
EGPRS) is set to GSM, W-CDMA (W-CDMA and HSDPA) is set to
WCDMA, and cdma2000 is set to MC1X.
This query command returns the set system name.
TX Power Measurement
TXANalyzer:RESults:TXPower?
This query command returns the TX Power Measurement result
values, <int 1>, <int 2>, and <real 3>.
N9360A Multi UE Tester CDMA2000 Programming Manual