Agilent Technologies N9360A Programming Manual page 86

5
Programming Command Reference
5-36
Sequence Number
CONFigure:SEQuence:NO 1|2
CONFigure:SEQuence:NO?
This command selects a Sequence Number. The sequence
number selected here applies to the commands that relate to
sequence. The default value is 1.
This query command returns the selected Sequence Number
with integer value of 1 or 2.
Band
CONFigure:SEQuence:BAND <<
BAND0:CELUS|BAND3:CELJP|BAND1:PCSUS|<<
BAND4:PCSKR|BAND6:IMT-2K
CONFigure:SEQuence:BAND?
This command specifies a Band in order to set the parameter of
each test sequence on each band. The parameter is
BAND0:CELUS, BAND3:CELJP, BAND1:PCSUS, BAND4:PCSKR
or BAND6:IMT-2K. At preset, this is set to BAND0:CELUS.
BS Level
CONFigure:SEQuence:AMPLitude <real>
CONFigure:SEQuence:AMPLitude?
This command specifies the amplitude (BS Level) in Signaling
status (except during measurement) in each band set by the
command. The allowable range is from -115 .0 to -18.0
Band
(dBm) in 0.1 steps. At preset, this is set to -75.0 (dBm).
N9360A Multi UE Tester CDMA2000 Programming Manual