Agilent Technologies N9360A Programming Manual page 171

N9360A Multi UE Tester CDMA2000 Programming Manual
• bit 8 (256) :Hard Handoff/Band Hardoff
• bit 9 (512) :System Handoff
The executed step is set to 1, and the others are set to 0.
The value in the parentheses is decimal value for each bit. Refer
to Setting and Querying the
<int 2> contains the system type currently being executed.
The return value is 2 (cdma2000), 1 (W-CDMA), or 0 (GSM).
When CDMA mode is EVDO:
<int 1> contains test contents currently being executed by
sum of the value of 11 bits as follows:
• bit 0 (1) :BS Call
• bit 1 (2) :RF Test
• bit 2 (4) :Connection Close
• bit 3 (8) :Time out error (Currently unused)
• bit 4 (16) :End (Stand-by status)
• bit 5 (32) :UATI Assignment
• bit 6 (64) :Session Opened
• bit 7 (128) :Session Close
• bit 8 (256) :Busy
• bit 9 (512) :Softer Handoff
• bit 10 (1024) :Channel Change/Band Change
The executed step is set to 1, and the others are set to 0.
The value in the parentheses is decimal value for each bit. Refer
to Setting and Querying the
<int 2> contains the system type currently being executed.
The return value is 2 (cdma2000), 1 (W-CDMA), or 0 (GSM).
Programming Command Reference
Registers.
Registers.
5
5-121