5
Programming Command Reference
5-64
This query command returns the setting of Probe Initial
Adjustment with integer. The range of the value is same as that of
the command parameter.
Probe Num Step
CONFigure:CONDition:PNSTep <int>
CONFigure:CONDition:PNSTep?
This command requires the installation of the Option C02.
This command is valid when CDMA mode is set to EVDO. This
sets the Probe Num Step in each band set by the
The allowable range is from 1 to 15 in 1 steps. At preset, this is
set to 5.
This query command returns the setting of Probe Num Step with
integer. The range of the value is same as that of the command
parameter.
Country Code
CONFigure:CONDition:CCODe <int>
CONFigure:CONDition:CCODe?
This command requires the installation of the Option C02.
This command is valid when CDMA mode is set to EVDO. This
sets the Country Code in each band set by the
36. The allowable range is from 0 to 4095 in 1 steps. At
page
preset, this is set to 0.
This query command returns the setting of Country Code with
integer. The range of the value is same as that of the command
parameter.
N9360A Multi UE Tester CDMA2000 Programming Manual
Band
command.
Band
command on