Agilent Technologies N9360A Programming Manual page 87

N9360A Multi UE Tester CDMA2000 Programming Manual
Measurement BS Level
CONFigure:SEQuence:MEASurementbslevel <real>
CONFigure:SEQuence:MEASurementbslevel?
This command specifies the amplitude (BS Level) for Time
Offset and Inner Loop Power measurements in each band set by
the Band command on
-115 .0 to -18.0 (dBm) in 0.1 steps. At preset, this is set to
-75.0 (dBm).
Max TX Power BS Level
CONFigure:SEQuence:MAXpowerbslevel <real>
CONFigure:SEQuence:MAXpowerbslevel?
This command specifies the amplitude (BS Level) for Max TX
Power measurement in each band set by the
The allowable range is from -115 .0 to -18.0 (dBm) in 0.1
steps. At preset, this is set to -104.0 dBm when CDMA mode is
set to MC1X and to -60.0 dBm when CDMA mode is set to
EVDO.
Min TX Power BS Level
CONFigure:SEQuence:MINpowerbslevel <real>
CONFigure:SEQuence:MINpowerbslevel?
This command specifies the amplitude (BS Level) for Min TX
Power measurement in each band set by the
The allowable range is from -115 .0 to -18.0 (dBm) in 0.1
steps. At preset, this is set to -75.0 (dBm).
FER BS Level
CONFigure:SEQuence:FERbslevel <real>
CONFigure:SEQuence:FERbslevel?
This command is valid when CDMA mode is set to MC1X. This
specifies the amplitude (BS Level) for FER measurement in
each band set by the Band
from -115 .0 to -18.0 (dBm) in 0.1 steps. At preset, this is
set to -104.0 (dBm).
Programming Command Reference
page 36. The allowable range is from
command. The allowable range is
5
Band command.
Band command.
5-37