Agilent Technologies N9360A Programming Manual page 166

5
Programming Command Reference
5-116
Code Domain Power
TESTs:MANual:CDPWr:PILot:STATe ON|OFF|1|0
TESTs:MANual:CDPWr:PILot:STATe?
This command sets whether to execute the Code Domain
Power:Pilot, Traffic (Fundamental) test. The parameter is ON (1)
or OFF (0). At preset, this is set to 1.
This query command returns the setting of the Code Domain
Power test with integer value of 1 or 0. The meaning of the
return value is same as that of the command parameter.
RX Power
TESTs:MANual:RXPower:STATe ON|OFF|1|0
TESTs:MANual:RXPower:STATe?
This command is valid when CDMA mode is set to MC1X. This
sets whether to execute the RX Power test. The parameter is ON
(1) or OFF (0). At preset, this is set to ON.
This query command returns the setting of the RX Power test
with integer value of 1 or 0. The meaning of the return value is
same as that of the command parameter.
Change System
TESTs:MANual:SYSTem GSM|GPRS|EGPRS|WCDMA|<<
HSDPA|MC1X|EVDO
TESTs:MANual:SYSTem?
This command switches the system (GSM/W-CDMA/cdma2000)
or mode (GSM/GPRS/EGPRS, WCDMA/HSDPA, MC1X/EVDO).
This command is valid in Stand-by status. GSM and GPRS are
valid when G00 option is installed in the Tester, EGPRS is valid
when G00 and G03 options are installed, WCDMA is valid when
W00 option is installed, HSDPA is valid when W00 and W06
options are installed, MC1X is valid when C00 and C01 options
are installed, and EVDO is valid when C00, C01 and C02 options
are installed. Each system mode is initialized at preset
(including *RST). Namely, GSM (GSM, GPRS, and EGPRS) is set
to GSM, W-CDMA (W-CDMA and HSDPA) is set to WCDMA and
cdma2000 is set to MC1X.
This query command returns the set system mode name.
N9360A Multi UE Tester CDMA2000 Programming Manual