Agilent Technologies N9360A Programming Manual page 91

5
Programming Command Reference
UATI Assignment Timeout
CONFigure:SEQuence:UATITimeout <int>
CONFigure:SEQuence:UATITimeout?
This command requires the installation of the Option C02.
This command is valid when CDMA mode is set to EVDO. This
specifies the UATI Assignment Timeout in Automatic Test. The
allowable range is from 5 to 300 (seconds) in 1 steps. At preset,
this is set to 60.
This query command returns the setting of UATI Assignment
Timeout with integer. The value range is same as that of the
command parameter.
Wait before Paging
CONFigure:SEQuence:WaitBeforePaging <real>
CONFigure:SEQuence:WaitBeforePaging?
This command is valid when CDMA mode is set to MC1X. This
specifies the Wait before Paging transmission time in Automatic
Test. The allowable range is from 0.0 to 99.9 (seconds) in 0.1
steps. At preset, this is set to 0.0.
The query command returns the setting of Wait before Paging
transmission time with real.
3GPP system
CONFigure:SEQuence:3GPPsystem <int>
CONFigure:SEQuence:3GPPsystem?
This command sets 3GPP system used in Test Sequence. The
allowable range is from 1 to 5 in 1 steps. At preset, this is set to
2. This command works when the Sequence Number 1 is
selected.
The query command returns the setting of 3GPP System with
integer. The range of the value is same as that of the command
parameter.
N9360A Multi UE Tester CDMA2000 Programming Manual 5-41