Agilent Technologies N9360A Programming Manual page 126

5
Programming Command Reference
5-76
Loopback Delay
CONFigure:CONDition:LDELay SHORT|MID|LONG
CONFigure:CONDition:LDELay?
This command is valid when CDMA mode is set to MC1X. This
selects the loopback delay in each band set by the
36, among SHORT, MID, and LONG. At preset,
command on page
this is set to MID.
This query command returns the set loopback delay.
Connection Wait
CONFigure:CONDition:CONnectionwait <int>
CONFigure:CONDition:CONnectionwait?
This command is valid when CDMA mode is set to MC1X. This
sets the response time for MS Call connection in Manual Test.
The allowable range is from 0 to 120 (sec) in 1 steps. At preset,
this is set to 0 (sec). When this is set to 0, the Tester
immediately responds to the call.
This query command returns the set response time with integer.
The range of the value is same as that of the command
parameter.
N9360A Multi UE Tester CDMA2000 Programming Manual
Band