Agilent Technologies N9360A Programming Manual page 102

5
Programming Command Reference
5-52
This command is valid when CDMA mode is set to MC1X. This
sets whether to include the Talk Test (BS Call) in a test flow. The
parameter is ON (1) for Run or OFF (0) for --- (skip). At preset,
this is set to 1.
This query command returns the setting of Talk Test (BS Call)
with integer value of 1 or 0. The meaning of the return value is
same as that of the command parameter.
BS Call (RF Test)
CONFigure:SEQuence:SIGNaling:BSCAll:RFTEST
ON|OFF|1|0
CONFigure:SEQuence:SIGNaling:BSCAll:RFTEST?
This command is valid when CDMA mode is set to MC1X. This
sets whether to include the BS Call (RF Test) in a test flow. The
parameter is ON (1) for Run or OFF (0) for --- (skip). At preset,
this is set to 1.
This query command returns the setting of BS Call (RF Test) with
integer value of 1 or 0. The meaning of the return value is same
as that of the command parameter.
RF Test
CONFigure:SEQuence:SIGNaling:RFTEST ON|OFF|1|0
CONFigure:SEQuence:SIGNaling:RFTEST?
This command defines whether to include the RF Test step in a
test flow. The parameter is ON (1) for Run or OFF (0) for ---
(skip). At preset, this is set to 1.
This query command returns the setting of RF test with integer
value of 1 or 0. The meaning of the return value is same as that
of the command parameter.
Softer Handoff
CONFigure:SEQuence:SIGNaling:SHOFf ON|OFF|1|0
CONFigure:SEQuence:SIGNaling:SHOFf?
N9360A Multi UE Tester CDMA2000 Programming Manual