Agilent Technologies N9360A Programming Manual page 42

4
Programming Command Guidelines
4-14
< Send Command to the Tester> CONF:LOSS:RFOU
1.0,1.0,1.0,1.0,1.0
<Send Command to the Tester> CONF:COND:BAND 1
<Send Command to the Tester> CONF:COND:3GPP 2
4
Configure test setting on a test mode screen. For example,
the Manual Test mode test sets as follows:
< Send Command to the Tester> TEST:MAN:RFCH:CHAN
BAND3:CELJP,76
5
Create an instruction message as follows for the operator to
turn on the mobile phone and wait for the Location Update
to complete.
<Display Message on the PC screen>
Turn on the mobile phone and wait until [P] is shown at
the [Location Update]. Then press [OK] button.
<Wait until the OK button on the PC screen is clicked>
6
Start the BS Call, and then check that the test flow changes
to the Talk/RF Test step.
< Send Command to the Tester> TEST:MAN:BSC
<Send Query Command to the Tester>
TEST:MAN:SIGN:STAT?
If the Response is not
Else, proceed to the next step.
7
Start the measurement.
<Send Command to the Tester> TRIG:IMM
8
To read the measurement results, wait until the
measurement ends.
<Send Query Command to the Tester> *STB?
If the Response is not
Else, proceed to the next step.
N9360A Multi UE Tester CDMA2000 Programming Manual
, re send the query.
2
, re send the query.
0