Agilent Technologies N9360A Programming Manual page 94

5
Programming Command Reference
5-44
bit 0 (1) :For testing RFCH1
bit 1 (2) : For testing RFCH2
bit 2 (4) :For testing RFCH3
bit 3 (8) :For testing RFCH4
bit 4 (16) :For testing RFCH5
bit 5 (32) :For testing RFCH6
The choices for each bit are 1 for Run and 0 for --- (skip). At
preset, this is set to 63 (all bits are set to 1).
MAX TX Power
CONFigure:SEQuence:TPOWer:MAXimum <int>
This command sets whether to include MAX TX Power test in the
test sequence. <int> is a sum of the values of all 6 bits as
follows:
bit 0 (1) :For testing RFCH1
bit 1 (2) : For testing RFCH2
bit 2 (4) :For testing RFCH3
bit 3 (8) :For testing RFCH4
bit 4 (16) :For testing RFCH5
bit 5 (32) :For testing RFCH6
The choices for each bit are 1 for Run and 0 for --- (skip). At
preset, this is set to 63 (all bits are set to 1).
MIN TX Power
CONFigure:SEQuence:TPOWer:MINimum <int>
This command defines whether to include MIN TX Power test in
the test sequence. <int> is a sum of the values of all 6 bits as
follows:
bit 0 (1) :For testing RFCH1
bit 1 (2) : For testing RFCH2
bit 2 (4) :For testing RFCH3
bit 3 (8) :For testing RFCH4
bit 4 (16) :For testing RFCH5
bit 5 (32) :For testing RFCH6
The choices for each bit are 1 for Run and 0 for --- (skip). At
preset, this is set to 63 (all bits are set to 1).
N9360A Multi UE Tester CDMA2000 Programming Manual