Agilent Technologies N9360A Programming Manual page 108

5
Programming Command Reference
5-58
Max TX Power BS Level
CONFigure:CONDition:MAXpowerbslevel <real>
CONFigure:CONDition:MAXpowerbslevel?
This command set the amplitude Max TX Power BS Level
measurement in each band set by the
36. The allowable range is from -115.0 to -18.0 (dBm) in
page
0.1 steps. At preset, this is set to -104.0 dBm when CDMA
mode is set to MC1X and to -60.0 dBm when CDMA mode is set
to EVDO.
This query command returns the set amplitude Max TX Power BS
Level measurement with real. The range of the value is same as
that of the command parameter.
Min TX Power BS Level
CONFigure:CONDition:MINpowerbslevel <real>
CONFigure:CONDition:MINpowerbslevel?
This command sets the amplitude Min TX Power BS Level
measurement in each band set by the
36. The allowable range is from -115.0 to -18.0 (dBm) in
page
0.1 steps. At preset, this is set to -75.0 (dBm).
This query command returns the set amplitude Min TX Power BS
Level measurement with real. The range of the value is same as
that of the command parameter.
FER Max Frames
CONFigure:CONDition:FER:MAXFrames <int>
CONFigure:CONDition:FER:MAXFrames?
This command is valid when CDMA mode is set to MC1X. This
sets the number of FER Max Frames. The allowable range is from
25 to 10000000 in 1 steps. At preset, this is set to 10000.
This query command returns the set number of FER Max Frames
with integer. The range of the value is same as that of the
command parameter.
N9360A Multi UE Tester CDMA2000 Programming Manual
Band command on
Band command on