Agilent Technologies N9360A Programming Manual page 129

5
Programming Command Reference
Replace File
CONFigure:FILE:REPlace
This command is used when duplicating the procedure file
between HDD and USB memory device. On the screen, the
HDD/USB softkey shows which device is being copied with
underline.
Device Control
CONFigure:FILE:DEVice HDD|USB
CONFigure:FILE:DEVice?
This command sets the device to the HDD or a USB memory
device. At preset, this is set to HDD.
This query command returns the selected device with strings of
HDD or USB.
File List Position
CONFigure:FILE:POSition <int>
CONFigure:FILE:POSition
This command sets a start number of the setup file list (File List
and File List Short commands load the setup file list). The
allowable range is from 1 to 300 in 1 steps. If this is set to value
from 301 to 2147483647, The result of File List or File List Short
query command is 0. At preset, this is set to 1.
This query command returns the set the start number.The range
of the value is same as that of the command parameter.
File List Request Number
CONFigure:FILE:LIST:REQuest <int>
CONFigure:FILE: LIST:REQuest
This command sets the number of the setup files (File List and
File List Short commands load the setup file list). The allowable
range is from 1 to 100 in 1 steps. At preset, this is set to 100.
N9360A Multi UE Tester CDMA2000 Programming Manual 5-79