Agilent Technologies N9360A Programming Manual page 192

5
Programming Command Reference
5-142
This query command returns the set Subtype.
RF Signal Output
TXANalyzer:RFOUtput ON|OFF|1|0
TXANalyzer:RFOUtput?
This command sets RF Signal Output status. The parameter is ON
(1) or OFF (0). At preset, this is set to 0. This works with RF
Output on the [Signal Generator] screen.
Averaging
TXANalyzer:AVERage OFF|<int>
TXANalyzer:AVERage?
This command sets whether to activate the averaging. The
parameter is OFF or <int> for the number of averaging times.
The allowable range of <int> is from 2 to 99. At preset, this is
set to OFF.
This query command returns the set averaging.
TX Power
TXANalyzer:TXPower:STATe ON|OFF|1|0
TXANalyzer:TXPower:STATe?
This command sets whether to execute the TX Power
measurement. The parameter is ON (1) or OFF (0). At preset,
this is set to 1.
This query command returns the setting of the TX Power
measurement with integer value of 1 or 0. The meaning of the
return value is same as that of the command parameter.
Frequency Error
TXANalyzer:FERRor:STATe ON|OFF|1|0
TXANalyzer:FERRor:STATe?
N9360A Multi UE Tester CDMA2000 Programming Manual