Agilent Technologies N9360A Programming Manual page 135

N9360A Multi UE Tester CDMA2000 Programming Manual
The value in the parentheses is decimal value for each bit. Refer
to Setting and Querying the
When CDMA mode is EVDO:
This query command returns the test step currently executed in
a test cycle. The return value contains the currently executed
status of 9 bits as follows:
bit 0 (1) :UATI Assignment
bit 1 (2) :Session Opened
bit 2 (4) :BS Call
bit 3 (8) :RF Test
bit 4 (16) :Softer Handoff
bit 5 (32) :Connection Close
bit 6 (64) :Session Close
bit 7 (128) :Measurement end with test result
bit 8 (256) :Measurement end without test result
(Aborted or Time out error occurred)
The executed step is set to 1, and the others are set to 0.
The value in the parentheses is decimal value for each bit. Refer
to Setting and Querying the
TESTs:AUTO:MEASure:SIGNaling:STATe:EXPand?
This query command returns the test contents currently being
executed and system type with integer value of <int 1> and
<int 2>. The return value of this query command differs
depending on the CDMA mode (MC1X or EVDO).
When CDMA mode is MC1X:
• <int 1> contains test contents currently being executed by
sum of the value of 13 bits as follows:
bit 0 (1) :Location Update
bit 1 (2) :MS Call (Talk)
bit 2 (4) :Talk (From MS Call (Talk))
bit 3 (8) :MS Release (From MS Call (Talk) or Talk)
bit 4 (16) :BS Call (Talk)
Programming Command Reference
Registers.
Registers.
5
5-85