Agilent Technologies N9360A Programming Manual page 141

N9360A Multi UE Tester CDMA2000 Programming Manual
bit 1 (2) :Session Opened
bit 2 (4) :BS Call
bit 3 (8) :RF Test
bit 4 (16) :Softer Handoff
bit 5 (32) :Connection Close
bit 6 (64) :Session Close
bit 7 (128) :Abort
Each bit is set to 0 if the test is passed or skipped, or each bit is
set to 1 if the test is fail. If there are no test results, all bits are
set to 1, and the value 255 is returned.
• <int 2> contains test contents currently being executed by
sum of the value of 12 bits as follows:
bit 0 (1) :Access Probe Power
bit 1 (2) :ILP (Down)
bit 2 (4) :ILP (Up)
bit 3 (8) :Max TX Power
bit 4 (16) :Min TX Power
bit 5 (32) :Frequency Error
bit 6 (64) :Multi-code Rho
bit 7 (128) :Time Offset
bit 8 (256) :Sensitivity/PER1
bit 9 (512) :Sensitivity/PER2
bit 10 (1024) :Sensitivity/PER3
bit 11 (2048) :Abort
Each bit is set to 0 if the test is passed or skipped, or each bit is
set to 1 if the test is fail. If there are no test results, all bits are
set to 1, and the value 4095 is returned.
The value in the parentheses is decimal value for each bit. Refer
to Setting and Querying the
• <int 3> contains the system type currently being executed.
The return value is 2 (cdma2000), 1 (W-CDMA), or 0 (GSM).
Programming Command Reference
Registers.
5
5-91