Agilent Technologies N9360A Programming Manual page 207

5
Programming Command Reference
RFGenerator:SUBType?
The command is valid when PILOT+MAC+CNTRL+TCH is set by
the Modulation command and 3 or 4 (Release A) is set by the
3GPP2 Configuration command. This sets subtype 0 or 2. At
preset, this is set to 0.
This query command returns the set Subtype.
RF Signal Output
RFGenerator:RFOUtput ON|OFF|1|0
RFGenerator:RFOUtput?
This command sets RF Signal Output status. The parameter is ON
(1) or OFF (0). At preset, this is set to 0. This works with RF
Output on the [TX Analyzer] screen
Change System
RFGenerator:SYSTem GSM|WCDMA|CDMA2000
RFGenerator:SYSTem?
This command switches the system (GSM/W-CDMA/cdma2000)
or mode. GSM is valid when G00 option is installed in the Tester
and WCDMA is valid when W00 option is installed.
This query command returns the set system name.
N9360A Multi UE Tester CDMA2000 Programming Manual 5-157