Agilent Technologies N9360A Programming Manual page 96

5
Programming Command Reference
5-46
When CDMA mode is set to EDVO, or When CDMA mode is set to
MC1X and F3R3, F4R3, or F5R4 is set by the Radio Configuration
command. <int> is a sum of the values of all the 6 bits as
follows:
bit 0 (1) :For testing RFCH1
bit 1 (2) : For testing RFCH2
bit 2 (4) :For testing RFCH3
bit 3 (8) :For testing RFCH4
bit 4 (16) :For testing RFCH5
bit 5 (32) :For testing RFCH6
The choices for each bit are 1 for Run and 0 for --- (skip). At
preset, this is set to 63 (all bits are set to 1).
Time Offset
CONFigure:SEQuence:TOFFset <int>
This command defines whether to include Time Offset test in
the test sequence. <int> is a sum of the values of all the 6 bits
as follows:
bit 0 (1) :For testing RFCH1
bit 1 (2) : For testing RFCH2
bit 2 (4) :For testing RFCH3
bit 3 (8) :For testing RFCH4
bit 4 (16) :For testing RFCH5
bit 5 (32) :For testing RFCH6
The choices for each bit are 1 for Run and 0 for --- (skip). At
preset, this is set to 63 (all bits are set to 1).
Sensitivity/FER
CONFigure:SEQuence:SENSitivity:FER <int>
This command is valid when CDMA mode is set to MC1X. This
defines whether to include Sensitivity/FER test in the test
sequence. <int> is a sum of the values of all the 6 bits as
follows:
N9360A Multi UE Tester CDMA2000 Programming Manual