Agilent Technologies N9360A Programming Manual page 93

N9360A Multi UE Tester CDMA2000 Programming Manual
The allowable range and preset values are as follows:
Table 5-11RFCH Allowable Range and Preset Value
Band Int Allowable Range
Off (RFCH1 is not 99999
available.)
BAND0:CELUS 1 to 799, 991 to 1023, 1024
to 1323
BAND1:PCSUS 0 to 1199
BAND3:CELJP 1 to 799, 801 to 1039, 1041
to 1199, 1201 to 1600
BAND4:PCSKR 1 to 600, 601 to 1300
BAND6:IMT-2K 0 to 1199
These query commands return the set Band and channel
number. The range of the value is same as that of the command.
Access Probe Power
CONFigure:SEQuence:APpower <int>
CONFigure:SEQuence:APpower?
This command defines whether to include Access Probe Power
test in the test sequence. <int> is 1 for Run or 0 for --- (skip).
At preset, this is set to 1. Access Probe Power test can be
executed only on RFCH1.
This query command returns the setting of the Access Probe
Power test with integer. The meaning of the return value is same
as that of the command parameter.
Inner Loop Power
CONFigure:SEQuence:INNErpower <int>
This command defines whether to include Inner Loop Power
(Down/Up) test in the test sequence. <int> is the sum of the
values of all 6 bits as follows:
Programming Command Reference
Preset Value
<enum> and <int> of each
RFCH
RFCH1: BAND0:CELUS, 1024
RFCH2: BAND0:CELUS, 991
RFCH3: BAND0:CELUS, 799
RFCH4: Off, 99999
RFCH5: Off, 99999
RFCH6: Off, 99999
5
5-43