Agilent Technologies N9360A Programming Manual page 111

N9360A Multi UE Tester CDMA2000 Programming Manual
This command sets whether to activate the averaging. The
parameter is OFF or <int> for the number of averaging times.
The allowable range of <int> is from 2 to 99. At preset, this is
set to OFF.
This query command returns the set averaging.
SCH Rate
CONFigure:CONDition:SCH:DRATe <enum>
CONFigure:CONDition:SCH:DRATe?
This command is valid when CDMA mode is set to MC1X. This
sets the SCH Data Rate when F3R3, F4R3, or F5R4 is set by the
Radio Configuration command.
The allowable range and preset values are as follows:
Table 5-12SCH Rate Allowable Range and Preset Value
Radio Configuration Allowable Range (kbps)
F3R3, F4R3 9.6, 19.2, 38.4, 76.8,153.6
F5R4 14.4, 28.8, 57.6,115.2, 230.4
This query command returns the set value of SCH Rate.
SCH Encoder
CONFigure:CONDition:SCH:ENCoder <enum>
CONFigure:CONDition:SCH:ENCoder?
This command is valid when CDMA mode is set to MC1X. This
sets the SCH Encoder type when F3R3, F4R3, or F5R4 is set by
the Radio Configuration command. The allowable range differs
depending on the settings made by the above SCH Rate
command.
The allowable range and preset values are as follows:
Programming Command Reference
Preset Value (kbps)
9.6
14.4
5
5-61