Agilent Technologies N9360A Programming Manual page 119

N9360A Multi UE Tester CDMA2000 Programming Manual
This query command returns the set low and high limits of Max
TX Power test with real separated by a comma. The range of the
value is same as that of the command parameter.
Min TX Power
CONFigure:CONDition:LIMit:TXPower:MINimum <<
<real LO>,<real HI>
CONFigure:CONDition:LIMit:TXPower:MINimum?
This command sets the low and high limits for Min TX Power test
in each band set by the
allowable range is from -99.99 to +99.99 (dBm) in 0.01
steps. At preset, this is set to -99.99 (dBm) (for the low limit)
and -50.00 (dBm) (for the high limit).
This query command returns the set low and high limits of Min
TX Power test real separated by a comma. The range of the value
is same as that of the command parameter.
Frequency Error
CONFigure:CONDition:LIMit:FREQuency <<
<real LO>,<real HI>
CONFigure:CONDition:LIMit:FREQuency?
This command sets the low and high limits for Frequency Error
test in each band set by the
allowable range is from -10000.0 to +10000.0 (Hz) in 0.1
steps. At preset, this is set to -300.0 (Hz) (for the low limit)
and +300.0 (Hz) (for the high limit).
This query command returns the set low and high limits of
Frequency Error test with real separated by a comma. The range
of the value is same as that of the command parameter.
Rho
CONFigure:CONDition:LIMit:RHO <real LO>,<<
<real HI>
CONFigure:CONDition:LIMit:RHO?
Programming Command Reference
Band command on page
Band command on
5
36. The
page 36. The
5-69