Removing The Fbu From The Holder; Installing A New Fbu; Concluding Steps - Fujitsu PRIMERGY RX4770 M1 Upgrade And Maintenance Manual

9.8.4.3

Removing the FBU from the holder

Figure 90: Removing the FBU from the holder
Ê Pull the FBU at a slight angle out of the holder.
9.8.4.4

Installing a new FBU

"Connecting the FBU cable to the FBU" on page 182
Ê
"Preparing the FBU" on page 181
Ê
"Installing the FBU holder onto the chassis" on page 183
Ê
9.8.4.5

Concluding steps

"Installing the memory rug" on page 307
Ê
"Installing memory boards" on page 223
Ê
"Reassembling" on page 53
Ê
"Connecting the server to the power source" on page 57
Ê
"Switching on the server" on page 58
Ê
A message indicates that the recalibration of the FBU starts automatically
and will be finished within a few minutes.
Ê If applicable, "Updating RAID controller firmware" on page
"Enabling SVOM boot watchdog functionality" on page 74
Ê
RX4770 M1
Upgrade and Maintenance Manual
Expansion cards and backup units
70.
191