Removing The Fbu With The Holder - Fujitsu PRIMERGY TX150 S8 Upgrade And Maintenance Manual

9.5.5.2

Removing the FBU with the holder

Figure 164: Removing the FBU holder from the chassis
Ê Carefully disconnect the FBU cable from the RAID controller (1).
Ê Lift up the green locking handle on the FBU holder (2) while sliding the FBU
holder in the direction of the arrow as far as it will go (3).
I
After that, the hooks on the air duct will rest in the wide ends of the
keyhole slots on the holder.
Ê Lift the FBU holder out of the chassis.
TX150 S8 / TX200 S7
Upgrade and Maintenance Manual
Expansion cards and backup units
237