Table of Contents
Advertisement
Expansion cards and backup units
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I
Configuration of network settings should be performed by the
customer. For more information, see section
settings recovery" on page
Ê If applicable, restore LAN teaming configurations, see section
replacing/upgrading LAN controllers" on page
9.6
Expansion cards in riser modules
9.6.1
Installing an expansion card in the riser module
Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
9.6.1.1
Preliminary steps
"Suspending BitLocker functionality" on page 105
Ê
"Disabling the boot watchdog functionality of ServerView Operations
Ê
Manager" on page 106
"Shutting down the server" on page 52
Ê
"Disconnecting the power cord" on page 53
Ê
"Getting access to the component" on page 54
Ê
"Removing the riser module" on page 84
Ê
"Installing the riser card" on page 83
Ê
322
320.
Upgrade and Maintenance Manual
"Note on network
"After
131.
Hardware: 10 minutes
TX2550 M4
Advertisement
Table of Contents
