Replacing Expansion Cards In Riser Modules; Preliminary Steps; Removing The Defective Expansion Card - Fujitsu PRIMERGY RX2560 M2 Upgrade And Maintenance Manual

Expansion cards and backup units
9.3.7

Replacing expansion cards in riser modules

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
controller or the system board.
9.3.7.1

Preliminary steps

Ê If applicable, "Note on network settings recovery" on page 304
"Suspending BitLocker functionality" on page 111
Ê
"Disabling SVOM boot watchdog functionality" on page 112
Ê
"Locating the defective server" on page 55
Ê
"Shutting down the server" on page 58
Ê
"Disconnecting the power cord" on page 59
Ê
Ê Remove all external cables from the expansion card to be replaced.
"Getting access to the component" on page 61
Ê
"Locating the defective component" on page 57
Ê
9.3.7.2

Removing the defective expansion card

Ê Remove the expansion card as described in section
cards from riser modules" on page
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section
page 294.
314
312.
Upgrade and Maintenance Manual
Hardware: 10 minutes
"Removing expansion
"Removing a slot bracket" on
TX2560 M2 / RX2560 M2