Concluding Steps; Replacing Expansion Cards In Riser Modules; Preliminary Steps - Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual

8.5.4.6

Concluding steps

Ê Install the riser module 2as described in section
2 (HL)" on page 88
"Reassembling" on page 73
Ê
"Connecting the power cord" on page 79
Ê
"Switching on the server" on page 82
Ê
"Resuming BitLocker functionality" on page 120
Ê
8.5.5

Replacing expansion cards in riser modules

Upgrade and Repair Unit
(URU)
Tools: Phillips PZ2 / (+) No. 2 screw driver / nut driver 5 mm
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
controller or the system board.
8.5.5.1

Preliminary steps

Ê If applicable, "Note on network settings recovery" on page
"Suspending BitLocker functionality" on page 95
Ê
"Disabling SVOM boot watchdog functionality" on page 96
Ê
"Locating the defective server" on page 61
Ê
"Shutting down the server" on page 65
Ê
"Disconnecting the power cord" on page 66
Ê
Ê Remove all external cables from the expansion card to be replaced.
RX2540 M2
Upgrade and Maintenance Manual
Expansion cards and backup units
"Installing the riser module
Hardware: 10minutes
Software: 5 minutes
261.
277