Gpu Cards In Riser Modules; Installing A Gpu Card In A Riser Module - Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual

Expansion cards and backup units
9.7

GPU cards in riser modules

9.7.1

Installing a GPU card in a riser module

Upgrade and Repair Unit
(URU)
Tools: – Phillips PH2 / (+) No. 2 screw driver
– Phillips PH1 / (+) No. 1 screw driver
– Hexagon screw driver 4.5 mm
Preliminary steps
▶
"Suspending BitLocker functionality" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Remove all riser modules, see
▶ If no riser module is installed: Remove the corresponding rear air grid, see
"Removing a rear air grid" on page
▶
"Removing the air duct" on page
▶
"Removing the crossbar" on page
Installing the GPU card in a riser module (example GPU NVIDIA A16)
The GPU cards A30/A40/A100/H100/RTX A4500/RTX A6000/A30X/
A100X have the same installation procedure.
284
50.
"Removing a riser module" on page
85.
80.
83.
Upgrade and Maintenance Manual
Hardware: 5 minutes
Software: 5 minutes
89.
50.
55.
49.
72.
RX2540 M7