Expansion cards and backup units
9.5.6.5
Connecting a battery backup unit to the expansion card
Ê If applicable, connect a FBU to the expansion card as described in section
"Installing a FBU" on page
9.5.6.6
Concluding steps
"Reassembling" on page 61
Ê
Ê Reconnect all external cables to the replaced expansion card.
"Connecting the server to the power source" on page 66
Ê
"Switching on the server" on page 67
Ê
"Enabling replaced components in the system BIOS" on page 86
Ê
Ê If
applicable,"Updating RAID controller firmware" on page
"Enabling SVOM boot watchdog functionality" on page 86
Ê
"Enabling BitLocker functionality" on page 92
Ê
9.6
GPGPU cards in riser modules (FL)
9.6.1
Installing a GPGPU card in riser module 1 (FL)
Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
9.6.1.1
Preliminary steps
"Disabling or suspending BitLocker functionality" on page 69
Ê
"Disabling SVOM boot watchdog functionality" on page 70
Ê
"Shutting down the server" on page 53
Ê
"Disconnecting power cords" on page 54
Ê
"Getting access to the component" on page 55
Ê
210
237.
Upgrade and Maintenance Manual
81.
Hardware: 5 minutes
Software: 5 minutes
RX2540 M1