Expansion cards and riser modules
Figure 109: Changing the jumper setting of JP10
▶ Remove the jumper from pin 2 and pin 3 of JP10 (1).
▶ Install the jumper on pin 1 and pin 2 of JP10 (2).
Concluding steps
▶
"Installing the riser module" on page
▶
"Installing the air duct" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
9.5.2
Removing an expansion card from a riser module
Upgrade and Repair Unit
(URU)
Tools:
Phillips PH2 / (+) No. 2 screwdriver
156
64.
59.
49.
56.
58.
Upgrade and Maintenance Manual
Hardware: 5 minutes
Software: 5 minutes
GX2560 M7