Replacing The 10X 3.5-Inch Hdd Backplane - Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual

Hard disk drive (HDD) / solid state disk (SSD)
Removing the defective 3.5-inch HDD module
▶ Remove the HDD module, see
page 149.
▶ If applicable, remove the HDD from the installation frame, see
HDDs or SSDs without installation frame" on page
Installing the new 3.5-inch HDD module
▶ If applicable, install the HDD in the installation frame, see
or SSDs without installation frame" on page
▶ Install the HDD module, see
page 147.
Concluding steps
▶ If applicable,
"Installing the front cover with lock" on page
▶ If the HDD is configured using a RAID controller with a RAID level higher
than "0", the rebuild will start automatically, see
rebuild" on page
7.4.5

Replacing the 10x 3.5-inch HDD backplane

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
152
"Removing a 3.5-inch HDD module" on
"Installing a 3.5-inch HDD module" on
106.
Upgrade and Maintenance Manual
136.
136.
"Performing a RAID array
Hardware: 15 minutes
49.
52.
53.
56.
"Handling
"Handling HDDs
69.
52.
RX2540 M6