Replacing A 8X 2.5-Inch Hdd Backplane; Preliminary Steps - Fujitsu PRIMERGY RX2520 M4 Upgrade And Maintenance Manual

Hard disk drive (HDD) and solid state drive (SSD)
7.3.8

Replacing a 8x 2.5-inch HDD backplane

I
Your server can be equipped with up to three backplanes. The replacing
procedure is always the same.
Field Replaceable Unit
(FRU)
Tools: flat screw driver
7.3.8.1

Preliminary steps

"Locating the defective server" on page 45
Ê
"Suspending BitLocker functionality" on page 67
Ê
"Shutting down the server" on page 48
Ê
"Disconnecting the power cord" on page 49
Ê
Ê Release all HDD/SSD modules and pull them out a few centimeters, see
section "Removing 2.5-inch HDD/SSD modules" on page
V
CAUTION!
The HDD modules need not to be removed completely. But if you
want to remove them nevertheless, make sure that all HDD/SSD
modules can be installed again into their original bay. Otherwise, data
may be lost.
"Getting access to the component" on page 50
Ê
"Removing the air duct" on page 61
Ê
"Removing the fan holder" on page 63
Ê
Ê If applicable, remove the SAS expander board holder, see section
"Removing the SAS expander board holder" on page
140 Upgrade and Maintenance Manual
Hardware: 15 minutes
135.
152.
RX2520 M4