Case IH AFX8010 Repair Manual page 1044

Sensing system Coolant level - Replace (B.50.A.95.93 - F.10.A.30)
AFX8010
Prior operation: ENGINE COOLANT SYSTEM - Drain fluid (B.50.A - F.35.A.20)
NOTE: Complete system does not have to be drained for sensor replacement. Drain only until coolant level is
below sensor.
1. Open the access door (1) and shielding to gain
access to the tank and sensor.
2. Disconnect the electrical connection from the
harness to the sensor. With a 24mm wrench remove
the sensor (1) from the tank (2) .
3. To install new sensor (1) install new O-ring (2) over
the threads until it is seated on the recessed groove
near the hex end. Apply Teflon thread sealant to the
sensor threads. Thread the sensor into the tank until
the O-ring becomes in contact with the threaded
bung. Thread in the sensor (approximately one
turn) until the arrow on the Hex head is facing up.
IMPORTANT: Do not over torque the sensor. The threads
are plastic and can easily strip. Apply only enough torque
until O-ring is gently seated, and arrow is facing up.
ATTENTION: It is important that you verify the arrow on
the sensor is facing up for the sensor to operate properly.
POWER PRODUCTION - ENGINE COOLANT SYSTEM
9675 1 27/05/2004
B.50.A / 36
1
10034690A5
2
10034689A5
3
50034910A5