Table of Contents
Advertisement
5A-218 Automatic Transmission:
Output Speed Sensor Replacement
Removal Procedure
1. Remove the battery tray. Refer to "Battery Tray
Replacement: ".
2. Disconnect the electrical connector (2) from the
output shaft speed sensor.
3. Remove the output speed sensor bolt.
4. Remove the output shaft speed sensor and the O-
ring.
Installation Procedure
1. Apply GM T-IV automatic transaxle fluid GM P/N
88900925 to the new output speed sensor O-ring.
2. Install the new output speed sensor O-ring onto the
output speed sensor (2).
3. Install the output speed sensor into the transmission
case assembly.
CAUTION
!
Refer to "Fastener Notice: ".
4. Install the output speed sensor bolt.
Tightening torque
Tighten the bolt to 6 N⋅m (53 lb in).
5. Connect the electrical connector (2) to the output
shaft speed sensor.
6. Install the battery tray. Refer to "Battery Tray
Replacement: ".
Advertisement
Table of Contents
Troubleshooting
