Suzuki XL7 2007 Service Manual page 1514

5A-104 Automatic Transmission:
Scan Tool Output Controls - Automatic Transaxle - AF33-5
Scan Tool Output
Control
Line PC Solenoid
Additional Menu
Selections
• The TCM commands the amperage, current, to the line pressure
Line PC Sol. Electrical
• The Line PC Sol. Electrical output control can be performed
• The TCM commands the amperage, current, to the line pressure
• The Line PC Sol. Functional output control can be performed
Line PC Sol. Functional
control solenoid in order to control transmission line pressure. As
the amperage increases, the line pressure decreases. As the
amperage decreases, the line pressure increases. The
amperage range is 0.20-1.10 and may be commanded in one-
tenth amp increments. If an amperage below 0.20 amp is
commanded, the message "Requested override current out of
range" appears on the scan tool display.
when the ignition is ON, and the engine is OFF. The reference,
commanded, amperage may be controlled within calibrated
limits. The scan tool parameter "Line PC Sol. Ref. Current"
changes, but the parameter "Line PC Sol. Actual Current" does
not change. The reference current remains until commanded
otherwise. If output control is attempted while the engine is
running, the message "Output control not allowed while engine is
running" appears on the scan tool display.
control solenoid in order to control transmission line pressure. As
the amperage increases, the line pressure decreases. As the
amperage decreases, the line pressure increases. The
amperage range is 0.00-1.10 and may be commanded in one-
tenth amp increments.
when the engine is running. The following control limits apply:
– When the transmission range is Park or Neutral, the
reference, commanded, amperage may be controlled within
calibrated limits. Both the scan tool parameters "Line PC Sol.
Ref. Current" and "Line PC Sol. Actual Current" change. Both
current readings remain until commanded otherwise.
– When the transmission range is not Park or Neutral, the
message "Transmission NOT is Park or Neutral" appears on
the scan tool display.
– Transmission range DTCs must not be active. If a
transmission range DTC is active, the message "Engine
running with transmission DTC present" appears on the scan
tool display.
Description