5A-292 Automatic Transmission:
11. Install the manual shift detent lever assembly (710).
NOTE
The park pawl actuator rod (709) must be
installed with the rod between the case and
the manual shift detent lever.
12. Connect the park pawl actuator rod (709) to the
manual shift detent lever assembly (710).
13. Using a screwdriver, lift the manual shift detent lever
spring (711) and rotate the manual shift detent lever
assembly (710) into position.
Reference: "Third Gear Band Apply Tube Installation".
Third Gear Band Apply Tube Installation
1. Install the 2 third gear band apply tube O-ring seals
(53).
2. Install the third gear band apply tube (52).
3. If needed, lightly seat the third gear band apply tube
into the transmission case assembly with a soft
mallet.
4. Install the third gear band apply tube retainer (51).
CAUTION
!
Refer to "Fastener Notice: " in Cautions and
Notices.
5. Install the 2 - M6 x 1.0 x 14 mm third gear band apply
tube retainer bolts (50).
Tightening torque
Tighten the third gear band apply tube retainer
bolts to 5 N⋅m (44 lb in).
Reference: "Transmission Fluid Baffle Installation".