Control Valve Body Assembly Installation
Reference: "Control Valve Body Assembly Assemble".
1. Rotate the transmission assembly so that the I.D. tag
is facing up.
2. Install 2 new case fluid passage seals (86) into the
transmission case fluid ports.
3. Shift the transmission into Neutral (N).
4. While holding the control valve body assembly (39),
connect the manual valve link (336) to the manual
shift detent lever assembly (710).
Automatic Transmission:
5. Install the 6 control valve body assembly to
transmission case bolts and hand tighten.
– 2 - M6 x 1.0 x 16 mm (34)
– 2 - M6 x 1.0 x 28 mm (35)
– 2 - M6 x 1.0 x 55 mm (47)
CAUTION
!
Refer to "Fastener Notice: " in Cautions and
Notices.
6. Tighten the control valve body assembly to
transmission case bolts in sequence.
Tightening torque
Tighten the control valve body assembly to
transmission case bolts to 10 N⋅m (89 lb in).
5A-333