Suzuki XL7 2007 Service Manual page 1747

Input and Output Speed Sensor Installation
CAUTION
!
Use care when installing the speed sensors
or damage may occur to the speed sensors
or the transaxle case.
1. Install NEW speed sensor O-rings (63).
2. Install the output speed sensor (62) and the input
speed sensor (73).
CAUTION
!
Refer to "Fastener Notice: " in Cautions and
Notices.
3. Install the M6 x 1.0 x 16 mm speed sensor bolts (61).
Tightening torque
Tighten the speed sensor bolts (61) to 5 N⋅m (44
lb in).
4. Connect the input and output speed sensor harness
assembly (71) to the speed sensors and the TCM.
Reference: "Drain Plug Installation".
Automatic Transmission:
Drain Plug Installation
1. Install a new gasket (820) on the drain plug (819).
CAUTION
!
Refer to "Fastener Notice: ".
2. Install the drain plug (819) into the case assembly
(17).
Tightening torque
Tighten the drain plug to 39 N⋅m (29 lb ft).
3. Install a new o-ring (824) on the transmission fluid
level indicator and lubricate with transmission fluid.
4. Install the transmission fluid level indicator.
5. Install the transmission fluid level indicator bolt.
Tightening torque
Tighten the indicator bolt to 10 N⋅m (89 lb in).
Reference: "Holding Fixture Removal".
5A-337