Suzuki XL7 2007 Service Manual page 1618

5A-208 Automatic Transmission:
Installation Procedure
CAUTION
!
Refer to "Fastener Notice: " in Cautions and
Notices.
1. Install the transaxle range selector lever and lever
nut.
Tightening torque
Tighten the nut to 16 N⋅m (12 lb ft).
2. Install the shift control cable (2) to the shift control
cable bracket (3). Ensure the shift control cable
retaining tabs fully engage the shift control cable
bracket.
3. Connect the shift control cable (1) to the transaxle
range switch lever (4).
4. Install the battery tray. Refer to "Battery Tray
Replacement: ".
Transmission Control Module Replacement
Removal Procedure
1. Remove the battery tray. Refer to "Battery Tray
Replacement: ".
NOTE
The transaxle manual shaft must be in
neutral (N) position prior to re-installing the
transmission control module (TCM).
2. Apply the parking brake and place control shift lever
in neutral (N).
3. Remove the manual shaft detent lever (2). Refer to
"Automatic Transmission Range Selector Lever
Replacement".
4.
Disconnect the electrical connectors from the TCM.
5. Remove the TCM bolts (3).
6. Remove the TCM (4) by sliding off of the manual
shaft.
Installation Procedure