Table of Contents
Advertisement
CAUTION
!
Refer to "Fastener Notice: " in Cautions and
Notices.
12. Tighten the 17 torque converter housing bolts in
sequence.
Tightening torque
Tighten the torque converter housing bolts to 29
N⋅m (21 lb ft).
Reference: "Second Coast Clutch Piston Travel
Measurement".
Second Coast Clutch Disassemble
Reference: "Fluid Pump Assembly Removal".
Special tool
J 23327 Clutch Spring Compressor
J 28585 Snap Ring Remover
J 41236 Coast Clutch Spring Compressor
J 45164 Spring Compressor Bridge
Automatic Transmission:
1. Using J 45164 (2), J 21420-2 (4) and J 23327-2 (1),
which are part of J 23327, compress the second
clutch spring.
2. Using J 28585 (3), remove the second coast clutch
backing plate retaining ring (230) from the fluid pump
assembly.
3. Remove the clutch plates (227, 228, 229).
NOTE
Do not let the tools contact the bushing
surfaces.
4. Install J 21420-2 (1) and J 23327-2 (3), which are
part of J 23327, and J 41236 (2) and compress the
second coast clutch spring (224).
5. Remove the second coast clutch spring retaining
ring (225) using snap ring pliers.
6. Remove the second coast clutch spring (224) from
the fluid pump assembly.
5A-297
Advertisement
Table of Contents
Troubleshooting
